Comments on: Teexpert Silicone Mold Making Kit, 63.48OZ/3.96lb Translucent Liquid Silicone Rubber for Mold Making Fast Cure Super Elastic Ideal for Casting Resin, Silicone, Candle, Soap Molds Making

By: jessie case

jessie case — Wed, 09 Apr 2025 01:55:05 +0000

Donât!
Iâm not sure what happened. This isnât a good product. Nothing turned out right at all.

By: SunnyDay

SunnyDay — Wed, 09 Apr 2025 01:55:03 +0000

Stays sticky.
I have bought this twice and you would think I would learn. The outside is cured but where the piece is in stays sticky no matter how long you leave cure. Don’t waste your money. Never again. Teeexpert go back to the drawing board on this one.

By: Cat

Cat — Wed, 09 Apr 2025 01:55:02 +0000

Great for learning, a bit sticky
Really great for molds and learning, if you’re new get a bigger size and even if you’re experienced as things happen, this eill prevent recording. Its a bit sticky but that could be on me. Super easy to use, clean up is good too.

By: MRW

MRW — Wed, 09 Apr 2025 01:55:01 +0000

My favorite
Looks great and holds its shape!

By: W. Bell

W. Bell — Wed, 09 Apr 2025 01:55:00 +0000

good or bad ? GOOD
I’ve had problems with this silicone, so far it stays very sticky. I bought a scale and measured by weight so we shall see if it cures this time. So far I’m disappointed in this silicone. If it cures this time I’ll redo my review.So here I am. I have been using it and started weighing it, I also set it on my resin heat pad while curing and it’s PERFECT!So, please buy this silicone, it’s a good product if used right . I’ll be a return buyer.

By: Jvtaurus

Jvtaurus — Wed, 09 Apr 2025 01:54:59 +0000

Great for items you need to be Food Safe
Its a nice translucent mold kit. Easy to measure, huge bottles, and bubbles were not a problem at all. Does say its better for food safe items, so that’s either a plus or minus depending on what you are molding. I had some toy parts that molded fine, and I did make a coaster that came out great too. Details were picked up. Overall, it’s a great mold mixture, and if you can catch it on sale, a great deal!

By: Amazon Customer

Amazon Customer — Wed, 09 Apr 2025 01:54:58 +0000

a ok
easy to work with

By: Kindle Customer

Kindle Customer — Wed, 09 Apr 2025 01:54:57 +0000

Easier than I thought it would be
I read a lot of the reviews, and thought this might not work out, but if you follow a few key points others have left here, you will be successful. Stir for a full five minutes. It’s boring and your hand will cramp up,but do it anyway, scraping the sides. I used a popsicle stick and wore gloves. Then, pour from about 2 feet above the mold. Start low, then as the liquid starts to come out, raise it up and pour from high up. It eliminates any bubbles really well. Then wait for 24 hours at least, before unmolding. I used this on a 3D printed resin part but I painted the resin down with three coats of acrylic spray, and that kept it from reacting. I got a great mold, detailed and flexible and am thrilled at these prices.